download the new version for mac Imagine 1.1.6

Steady on: Indicates that charging is complete The charging process should be kept as continuous as possible until the charging instruction is completed, which is conducive to the accurate capacity determination of the fuel gauge.ġ.2 The updated charging indicator status is as follows: The relevant precautions are as follows:ġ.1 After updating the firmware, please perform 4 full charge and full discharge cycles in a row, after which the fuel gauge will measure accurately. Just after updating the firmware, before the 4 times of charge and discharge are completed, the displayed power error is large, so don’t pay attention to it. After the upgrade, the battery voltage will no longer be used as the management data, but the battery capacity measured by the battery gauge will be used as the management data. The built-in battery gauge is enabled to manage the battery cell. Consistent performance is achieved by connecting a wired USB-C LAN dongle to the HOST connector using a LAN cable between the radio and access point.ĪTTENTION: If you have firmware older than the previous January 17 update, please see the below information regarding the battery management update ġ. # The X6100 internal WiFi antenna is only usable when adjacent to the access point. More information about wfview is found at. wfview also allows older radios to be accessed over the internet, for full control and low-latency audio streaming. wfview supports rig control over ethernet/wifi as well as over the traditional USB serial CIV bus. wfview runs on recent versions of Linux, macOS, and Windows. wfview can run on hardware ranging from the $35 Raspberry Pi to laptops to desktops. wfview allows for full radio (remote) control from a computer keyboard and basic control from a numeric keypad. wfview shows the gorgeous spectrum display on whatever display is connected, including projectors, touch screens, and TVs. Wfview is a free and open source program that allows many modern Icom ham radio transceivers (such as the Xiegu X6100, IC-7300, IC-9700, IC-7610, IC-R8600, the IC-705, and many others) to be controlled via a computer. Added wfview server to enable support for wfview, see included ‘圆100 wfserver.pdf’ file for setup instructions.

Download the new version for mac Imagine 1.1.6